CoolBot Guide_Thai Change setting between Fahrenheit and Celsius YouTube

Coolbot Instructions. CoolBot DIY WalkIn Cooler Installation Guide Our step by step install videos will get you cooling in no time Page 13: Changing Settings On The Coolbot Pro CHANGING SETTINGS ON THE COOLBOT PRO The CoolBot will always remember all your last settings even if it has been unplugged for a long time.

Common questions about the CoolBot, A/Cs, Uses, humidity, winter use, etc If you chose P1, CJ, or Fr with the Jumper connected to the CoolBot, the CoolBot will switch to its Wi-Fi Configuration mode

CoolBot DIY WalkIn Cooler Installation Guide

The CoolBot uses 2 sensors (ROOM and FIN sensors), the HEATER cable (red tip) and a programmed micro-controller to direct your air conditioner to operate in such a way as to cool the room to a set temperature in between 33°F/0.5°C and 65°F/18°C without freezing up. The provided Data Cable is specific to the CoolBot Pro/Jumper - standard phone cable will not work and may damage your CoolBot Pro/Jumper Our step by step install videos will get you cooling in no time

(PDF) INSTRUCTION MANUAL AND TROUBLESHOOTING GUIDE · 20180222 · 2. If you chose P1, CJ, or Fr with the Jumper connected to the CoolBot, the CoolBot will switch to its Wi-Fi Configuration mode QUICK START SET UP GUIDE STEP 1 Plug the wires into the corresponding labelled ports at the bottom of the CoolBot temperature controller

CoolBot Pro with WiFi for DIY Walkin Coolers. Common questions about the CoolBot, A/Cs, Uses, humidity, winter use, etc STEP 2 Mount the CoolBot on the wall next to the A/C's control panel side